This post explains the idea of creating custom characters on any LCD ( e-g on 16×2 LCD ) which has HD44780U controller in it. Almost all 16×2 or 20×2 LCDs have HD44780U controller in them[1]. This controller provides the functionality of CGRAM ( Character Generator RAM ). We can write character patterns on this RAM and then they can be easily displayed on the LCD. The code for custom character generation using PIC16F84A microcontroller and Proteus simulation can be downloaded from the ‘Downloads‘ section at the bottom of this page.
If you don’t know how to interface LCD with PIC16F84A in 8bit mode, then you should read this post first. The required circuit for displaying custom characters on LCD is shown below.
PORTB is being used as data bus for the LCD. Also, RA1 pin is used as RS (Register Select for LCD) and RA0 pin is used as E (Enable pin for LCD).
A crystal of 20 MHz is used here. You can use any crystal value from 0 to 20MHz in this circuit. Close-up picture of the LCD is shown below.
Figure 2 shows the custom characters displayed on the LCD by running the code.
How to generate custom character ?
I am going to explain custom character generation using an example. In the figure 2, first character displayed on the LCD is named ‘Curvy Object’ in the code. To generate this character, First make a box of 8 by 5 dots. Then fill the dots required to make the custom character you want to display. Following figure explains this concept.
After filling the dots, find out the value of each line. For example, ( in the figure 3 for ‘Curvy Object’ creation ) first line has a value of 0x01, because only first dot ( at 20 position ) needs to be displayed. Then second line has a value of 0x02, because only one dot at 21 position needs to be displayed. Similarly, third line has a value of 0x04, fourth line has a value of 0x08 and fifth line has a value of 0x10. Sixth line has the two dots to be displayed, hence 0x10 + 0x01 = 0x11 is it’s value. Seventh line has all the dots to be displayed, which corresponds to a value of 0x10 + 0x08 + 0x04 + 0x02 + 0x01 = 0x1F. Eight line has no dots to be displayed, so it has a value of zero. After finding out these values make an array of these values as shown in the figure 3. This array named ‘CurvyObject’, which has 8 bytes of data will be transmitted to the CGRAM of LCD.
Code
The code for the InitLCD() function is shown below[3]. This function is used to initialize the LCD properly with the custom characters.
Downloads
Custom character display on LCD code for PIC16F84A was compiled in MPLAB v8.85 with HI-TECH C v9.83 compiler and simulation was made in Proteus v7.10. To download code and Proteus simulation click here.
For more detail: How to display custom characters on LCD using PIC16F84A
The post How to display custom characters on LCD using PIC16F84A appeared first on PIC Microcontroller.